Originally Posted by
J. Kłapacz
Hi everyone. Someone had a problem that the motor was crooked in relation to pod lower plate, about 1.5mm.
The motor mount is perfectly straight. Rear pod lower plate is straight too.
The problem is only with Orion vst2 motors, I tried Muchmore and it's fine. I tried to use washers, but still the same, I checked on two orion motors. Many people use these motors at 1:12 what can be the reason and how fix it?
I'm very skeptical the motor is the problem. A bent motor side pod plate would cause that. Check again for bent parts. The only thing I could imagine with the motor would be a can screw that is sticking out so the can won't tighten flush to the mount.