60a first version.

Anyone run this esc? In the manual it says that if in blinky mode the white LED should go out. I cannot get it to go out. Also It shows that each setting has a factory default setting. Is there a way to reset it to default? As far as I can tell this one only used one of those old programming "cards" or direct. Anyone know if this can be programmed by any programming box or software?

Also.. running this as well.

But when I get the UT Link software running and I can.. it identifies this and the programming card.. But I assume I should have downloaded firmware files to upgrade it???? I cannot find those firmware files anywhere on the net??? ANYONE???

James