R/C Tech Forums - View Single Post - Brushless motor timing accuracy
Thread: Brushless motor timing accuracy
View Single Post
Old 01-16-2019, 02:09 PM
  #8  
glennhl
Tech Elite
iTrader: (16)
 
Join Date: Sep 2013
Location: Arizona
Posts: 2,088
Trader Rating: 16 (100%+)
Default
Originally Posted by tbrymer
Since I've used my analyzer on a crap load of motors, I know that mine works to some degree. I personally won't use a sensor board if it's more than 2 degrees out of phase. The worse motor I've bought has been out by 4 deg, but others have seen worse.
Yea, whenever you have a motor with a sensor board out by 4 degrees or more, you sell it to me.

Just kidding
glennhl is offline  
Reply