Originally Posted by
waitwhat
Read the manual more carefully.
On page 67 it gives all the options you can assign to SW1. Dual rate is not one of the options you can assign to SW1.
On page 66 it shows Dual Rate can be assigned to DL1 or any of the DT switches.
You are going to have to assign dual rate to dl1, and then set the resolution of the adjustment. If you set the resolution to 40, moving dl1 one detent will change dual rate from 100 to 60. I would set the resolution to 10, which would mean that it would take 4 detents to go from 100 to 60. This would give you 4 steps instead of one from 100 to 60.
that did work.... I seen that sw1 does not do d/r.... I was hoping.
I do have DL1 assigned with resolution of 40 as your said...
60 is normal.. and index finger rotates DL1 forward one click to 100... and 2 clicks remain at 100..
as its harder to rotate counterclockwise as easy... back to 60 is not that difficult.. but 2 clicks give me 20 then zero...
I just have to be careful.. with it.
Thank you again....