Originally Posted by
chuck_thehammer
I wish that were true.... there is NO change pressed or not... if I have it set at 60 or 100... it does nothing..
using the control switch or the menu to change the numbers.
its like SW1 is not connected to anything.
Read the manual more carefully.
On page 67 it gives all the options you can assign to SW1. Dual rate is not one of the options you can assign to SW1.
On page 66 it shows Dual Rate can be assigned to DL1 or any of the DT switches.
You are going to have to assign dual rate to dl1, and then set the resolution of the adjustment. If you set the resolution to 40, moving dl1 one detent will change dual rate from 100 to 60. I would set the resolution to 10, which would mean that it would take 4 detents to go from 100 to 60. This would give you 4 steps instead of one from 100 to 60.