I'm new to setting up pan cars, but am I correct in that rear droop is controlled by centre shock length? I seem to have quite a lot, around 4mm with kit settings on new contact lilac WGT tires.

​​​​Regarding tires.. Do I have to true the tires down as the fronts are 61mm and the rear are 62.5mm. I have ordered some extra shims to bring the ride height down as it is pretty high at about 7mm with all the shims I have.

One last question, is it possible to set side spring preload on the X10? Do I add and remove shims or can it be set by adjusting the set screws? The manual said leave 0.5mm showing on the top of the set screw but this doesn't allow much room for adjustment plus I'm not sure about the bottom shim.

A few initial settings seemed off in the manual, such as front camber link gap and centre shock preload. I know it depends on the wheels and tyres but there was far too much camber on the front wheels and 5mm preload seemed way too much on the centre shock?