Hello all, Just built a 3.3 and as expected the piston is getting stuck at TDC. I tried warming the engine before starting it and just turning it over for a while without a plug to hopefully free it up a bit but nothing's helping. The EZStart can spin it half a revolution until it gets to TDC then it sticks. Once in a while I can get the ezstart to spin it a few more revolutions before getting stuck but that's it. I even tried putting a pull start on it and I keep breaking the cord. What can I do to free this up a bit? A friend of mine bought a revo with a 3.3 about a year ago and he had the same issue. We ended up hooking the EZStart remote up to a 12v car battery to give it enough juice to spin. Once it was running a but the issue went away. I feel if I could get mine to at least run once I could have the same result.