Originally Posted by
golgi
When I tried to run my KO BSx3 brushless servo which is HCS capable in SSR mode, the starting center point was at least 20 degrees off from where the starting center point is in SHR mode. I thought that was odd. However, otherwise it seems to work fine in that mode. I just didn't want to keep it in the mode since was doing the odd thing on starting center point. Can anyone else confirm that they had a similar experience with KO servos and SSR? Thanks
I'm not an expert but If you turn the servo on and it centers where ever. You than you install the horn and adjust sub trim to center it. Then you adjust EPA's and your done. What difference does it make where it centers?..... as I said sub trim ... As long as the servo can swing lock to lock what more do you need. You that anal? Just sayin...