Originally Posted by
RazorRC
Are any of y’all bending inner front hinge pins? I literally bend one every couple of packs, oftentimes taking out an arm or the pills. Am I the only one?
Which is weird because I rarely break anything on any of my other kits, including my EB410.
Getting frustrating, and I wish I could just chalk it up to bad driving, but I’m really not that terrible of a driver, honest!
I bent one of my pins along with busting the front bulkhead on my ET410 after trying to learn a new layout at the club in my area. I was taking some big air and missed the landing ramp but came down on the 2x4 board that is used for lane dividers... 95% of the time I don't break when I take a bad landing like this, but sometimes I don't get so lucky. Here are some pics of the jump for reference, not my ET410 in the pic, but just to show you how the boards are positioned where I experienced the break from taking the full jump, I have since learned to not risk the jump and layup with the step on-step off rather than clearing the whole thing:
