I see, I had been countering tweak after a crash/run using the coin trick so the side springs were certainly far off from each other as far as tension. It actually got to a point where one side was nearly bottomed out while the other side had no tension - all I did was set them back to have no tension and the process repeated itself. Doesn't seem I've been following the best practices but I'm still new to this and learning. I appreciate your help.
I do have another question - when you say to make sure that the chassis was still flat - how do you go about correcting this? Or is this essentially what tweak is? And the fact I have an aluminum chassis - does this make any difference?