Originally Posted by
jdawg81
I'm assembling the mid motor conversion kit and I have a question about the AM77MM part as it's a bit different than what's shown in the instructions. The instructions shows the bottom of this part to be flat but mine is raised up on one side to allow a gap between the part and the chassis. When installing the one screw at the end of this part am I supposed to install a washer between AM77MM and the chassis?
similar to motor mount on the A-800X standard motor position chassis, a spacer and screw can be used in that hole to stiffen the chassis, or leave the screw out to allow for more chassis flex.
-a
:-)