Originally posted by AdrianM
Moot - The values are all going up because the speedo thinks trigger neutral is the throttle high point. This happens if you make a error in setting it to the transmitter.
To set the speedo to your transmitter follow this procedure:
1. Make sure you radio is set to 100% end points for brake and throttle and no more. LRP used to recommend setting your radio to 140% before setting your speedo. Keyences do not like this.
2. Turn it on your transmitter and speedo.
3. Hit the center button to enter the "Set" mode.
4. Push the center button and hold it until your see "nutr"( approximately 6 seconds). If you saw "nutr" right away you pushed too far to the right and you are not in the right place. If you did it right you will see all the LED bars on the display count up then "nutr " appears.
5. Once you see "nutr" do not touch your transmitters trigger ands hit the right button on your speedo. You just set the neutral point.
6. The display will switch to "dr_hp". Pull full throttle on the trigger, hold it and while holding full throttle hit the right button on your speedo. You just set the throttle high point.
7. The display will switch to "br_hp". Push full brake hold it and while holding full brake hit the right button on your speedo. You just set the brake high point.
8. The display will switch to "Set" and you can now program your speedo by hitting the right button.
Just like on any other brand of speedo you have to move quickly. You have 5 seconds to hit the right button in every mode If you go too slow the speedo will move on to the next setting ands you will need to start over.
will give it a go! thanks for the help
