R/C Tech Forums - View Single Post - Tamiya TRF419
Thread: Tamiya TRF419
View Single Post
Old 07-01-2018 | 11:08 AM
  #3916  
Raman's Avatar
Raman
Tech Champion
iTrader: (106)
 
Joined: Aug 2007
Posts: 5,853
From: Houston
Default

Originally Posted by airbiscuit
Changes:

Rear diff was at 2k. Changed to 3.5k today.
Front/rear shocks was at 350. Changed rear to 400.
Front springs was SMJ yellow. Rear was SMJ red. Changes are to front only to SMJ red so both are on reds.
Front : 3.5mm spacers on bulkhead. Zero on c hub. Initially was 3mm/0.5mm.

Left untouched:

No changes to front & rear arms spacer. Both are on 3mms on the FF block & RR block.
Drop is 5mm front 4mm rear. Measured according to the 419x/xr setup sheet.
1 degree camber all around
1 degree toe out on the front. 2 degree in on the rear
Ride height : 5.2mm front 5.4 rear
Rear : 2mm spacers on bulkhead. 1mm on upright.

Now I am getting better steering but on power on corner exit, the rear side spins out.
increase front drop a 1/8 of turn and try again. Then after you test it, increase another 1/8
Raman is offline