Originally Posted by
XLosiguy
Thanks again for the tip. I ended up with two per wheel bearing to correct the "rim scrub" and the side effect was no more slop (in and out) of the outdrives.
I'll be testing a full set of 2mm offset hubs next week (for added stability, not the rim scrub), which will most definitely eliminate the scrubbing problem, but will continue to use the O-rings just for the no slop benefit.
well.... It's been awhile since that post and Tower hobbies dropped the ball big time. I never received the hubs (OR THE LYNX4s RADIO), but they were nice about it all and I did end up with the radio (from Amain). I forgot to order hubs...🙁
After taking with one of our fast guys, he suggested stock (0-offset) or at MOST 1mm offset if I absolutely HAD to try them.....and I DO!
I'll report my results when I get/test them.