R/C Tech Forums - View Single Post - Orca B32 calibration
Thread: Orca B32 calibration
View Single Post
Old 06-01-2018 | 10:14 AM
  #2  
EbbTide's Avatar
EbbTide
Tech Elite
iTrader: (39)
 
Joined: Nov 2012
Posts: 4,264
From: Bay Area, Ca
Default
Originally Posted by jgil089
I'm hoping htere is an easy solution to this. I havw just installed an new Orca B32 and Blitreme 17.5T combo in my Lazer and nneed to calibrate it to my Sanwa MT4S / 462rx. The instrustions just say to have the tx at full brake, turn on the ESC and it will beep twice, then go full throttle and it will beep twice, then neutral and it will beep once and its done. The car won't run at all.

Mine doesn't beep

I have tried changing the tx throttle channel to rev or nor but now differemce3

Anyone dealt with this before?
do you have the sensor wire connected between the motor and ESC ? And if so make sure they are fully seated.

and it could help to rebind the receiver to the remote. The radio should be in NOR mode.
EbbTide is offline  
Reply