Originally Posted by
vwduud
Right. These were the settings BEFORE attempting to enable Push Control. I changed Push Control from 'off' to 25, then to 80, with no visible results. I have been using a Futaba 4PX since they came out. This is the same radio that I've had since buying a Gen3 Rx8.
On your 4px have you changed your throttle to 70/30 and have you more importantly turned off your BLS mode on Ch2? This last part is CRITICAL on an ESC if your read the manual.
Push control is activated by the ESC knowing how much time has been spent at WOT or wide open throttle, and then when neutral is seen by the ESC, it will hold that throttle on for the setting set in the ESC. If no neutral is seen, no push control will be enabled for example.