[QUOTE=Giorgio;15220362]We - and other manufacturer - state "Due the nature of the aluminum material and the machining process, it is normal that the chassis may be slightly bent in the longitudinal direction."
Slighlty means between 0 and 0.1x mm tolerance.
Unfortunately 4.6mm is a little bit more than "slightly".
Seems that the previous owner went a little too far about "gentle kiss to the wall"...
[/QUOTE
thank you for taking the time to respond. Laying flat, it's close to .5 mm in rear and almost 1mm in front so looks like I'm the proud owner of a very nice paperweight 😂. #usedcarproblems