R/C Tech Forums - View Single Post - Hitec x4. Low voltage error
Thread: Hitec x4. Low voltage error
View Single Post
Old 04-29-2018 | 04:08 PM
  #2  
rustyus's Avatar
rustyus
Tech Master
iTrader: (1)
 
Joined: Apr 2014
Posts: 1,296
From: PA
Default
Possibly thinking about using NiMh chemistry setting to bring up voltage on a LiPo pack? Only do it until voltage of cells is above 3v/cell, then try a balance charge again.

How low did the voltage drop? If a LiPo pack was discharged too much, battery health could have been diminished greatly.
rustyus is offline  
Reply