Originally Posted by
sonny8692
Hi, newbie when it comes to electronics. Can someone tell me what is the use of the sensor wires on the brushless motors?
Where does it connect? or do you use it only for servicing or adjusting the motor? I have a Maclan 21.5 short stack paired with a
Maclan Pico 100a. Sorry if this has been discussed, but I can't seem to find an answer to this.
Thanks in advance
the sensor wire is necessary and it goes from the motor to the ESC. The sensor wire plugs are keyed so plugging them in backwards should not be possible. The sensor port should be easy to find on the motor. The port on the ESC is under the solder tabs