Originally Posted by vwduud

I've used Push Control in the past (back in 2014, with a Gen1 Rx8). Worked great for the setup I was running back then.

I'm trying to enable again, now with a Rx8 Gen3 running 258 firmware. I am setting it with the Windows PC Tekin Hotwire app. While it accepts the setting, I am not seeing the result of this setting in the car. To re-familiarize myself with how much is needed, I initially set Push Control to 25 and tested in my driveway (same thing I did in 2014, with positive, obvious results). When I didn't see the results I was expecting, I increased the value from 25 to 80. Still nothing. Did a quick Google search (and here on RCTech) only to try increasing my Neutral Width (from 5 to 15). Still not seeing Push Control adding any extra creep after coming back to neutral, whether coming off of full throttle or anywhere in between.

Can anyone offer a solution?