Originally Posted by
Adamska27
So, yeah, that's nonsense
Cuz the rules read like this
8.4.7.2.7 ROAR Spec 17.5 motor: The three slotted stator must be wound with 17.5 turns of 2 strands
of a maximum diameter of .813 mm per slot. No motor will be approved with resistance less than 35.4
milliohms* between any 2 phases of the motor (AB, AC, BC), when measured at 25C with an Instek GOM
802 milliohm meter.
So, the stack length will be the minimum to make the resistance spec, and boom, u got a motor design
And yet a bunch of motors that were approved against these specs are currently failing tech.