Ive had a V2 in a box for a couple years now and building it up.
Im sort of confused on one spot, so i was hoping someone could help out. I have not built a ball diff since the 1st original associated stealth tranny came out.
Its concerning the ball diff.
From the picture below, i have put some arrows and a circle where im confused.
It came with 3 spacers (circled), and it says prepared with 3 pcs.
The exploded picture of the diff shows just one of the spacers.
Am i to build it with 3 spacers? it doesn't seem possible that they will all fit in there and it will definitely be less space in there than the opposite side for the drive shaft.
Does anyone remember if they used all 3 of those spacers that came in the kit.
How tight should i get that diff with the screw?
thanks in advance guys.