Originally Posted by
rcfiend
That helps. Does it matter whether the markings (arrow, .50) is on the inside or outside?
Thx.
Yes, it matters, and they must face the same direction. If your right side adjuster has the arrow and .50 markings towards the right wheel then your left side adjuster will also need the arrow and .50 markings towards the right wheel. This means when setup correctly the markings will be on the inside on one side and on the outside on the other side. Which side has them on the inside and which side has them on the outside will be dependent on if you are running the long wheelbase or short wheelbase and if you are running them in the lower axle or higher axle position to accommodate for different rear ride heights.