Originally Posted by
grabbem88
No it’s apply button randy
My rsx gen2 and gen3 rx8’s don’t do this.
If I check esc by scrolling through buttons every change that I can see is there but if I plug
It back in to the Hotwire it’s all back to default mode
Ok, that's good to know. Since this is the case, write down all of your settings and do the following please:
Power up the ESC; hold BOTH buttons down for 4-5 seconds at the same time. This is a "Factory Reset" and is a good idea the ESC is doing ANYTHING out of the ordinary or norm.
Once done try a few settings taking note of their setting value, then hit "apply." Then unplug the ESC from the HW and plug it back in; hit "current settings" to assure they're the values you put in.
LMK