Hello TRiN,
I would say it depends on the Kick-up setting as well..
Also if You change the B-Plate the bump steer need to be adjusted as well..
Cheers..
Originally Posted by
TRiN
Forgot to mention slightly longer hardware is used to 'store' all the bumpsteer washers (4 of them) and 'reset' the bumpster adjustment when changing between the 15deg, 17.5deg and 20deg caster blocks:
15deg caster - use
0mm bumpsteer washers on top, store all 4 washers on the underside of the ackermann plate
17.5deg caster - use
2mm bumpsteer washers on top, store the remaining 2 washers on the underside of the ackermann plate
20deg caster - use all
4mm bumpsteer washers on top
Z087 Flat Head Screw M3x20mm - previously Z086 M3x18mm
114489 Aluminum Washer 3x6x1.0mm Orange (20) - Part# of the washers mentioned in my previous post.