Originally Posted by
hipwell
Hi guys.
Can somebody help me with my 419.
I just cannot get equal left right steering without having to alter the end points by quite a lot.
Both track rods are the same length
I use an x-ray servo saver using the top middle hole and I have this pointing directly up with the wheels central.
Is this wrong? Should it be at an angle?
Your servo and your horn are at neutral, when you switch on on radio?
Your D/R, EPA and Sub Trim (!) are at 0 in your radio?
Your servo horn is then aligned as stated in the manual?
Begin with this 3 points from scratch. Then adjust yor steering rod that the two steering levers are perfectly straight aligned with your chassis. Then adjust your steering linkages with toe out 0.5-1.0 degrees. EPA fine tuning will be the last step. Maybe a little bit Sub Trim. For perfect results you need a setup station.
Cheers.