Originally Posted by
hardijs
hi,
could somebody give a good starting point how to setup my newly bought Xerun V3.1?
I drive b64
track is tight hight traction carpet track.
I drive mod class with 5.5t motor.
Any advise is welcome
Here is my V3.1 setup
Fwd/Brk
LVC – auto voltage cutoff
ESC Overheat – disabled
motor heat – disabled
PR Sw point – 50%
1st punch rate – 15
2nd punch rate – 15
Th Curve – Linear
Neutral Range – 6%
Drag Brake – 8%
Brake Strength – 75%
Initial Brake – =Drag Brake
Brk SW Point – 50%
1st Brk Rate – 15
2nd Brk Rate – 15
Brake Curve – Linear
No Timing Function used