R/C Tech Forums - View Single Post - RCHourglass DIY Lap Timing (AKA Cano revised)
Thread: RCHourglass DIY Lap Timing (AKA Cano revised)
View Single Post
Old 01-16-2018 | 07:12 PM
  #42  
howardcano's Avatar
howardcano
Tech Elite
iTrader: (37)
 
Joined: Jan 2012
Posts: 3,784
From: Olathe, KS
Default
Originally Posted by Snowblind
My prototypes don't look as good/neat as yours

Here is the transponder...


I dont have a voltage reg on this one. I don't have a one with a low enough drop out voltage. I will order some next time i order some stuff from digikey. These close up pictures show some ugly solder joints.



Let me know if the picture don't show up.



I 3D printed an antenna holder/short circuit protector

The loop amp:


The decoder:
They look pretty darn good to me. And when they function, they're downright beautiful!
howardcano is offline  
Reply