R/C Tech Forums - View Single Post - Receiver controlled on/off switch for higher voltages
Thread: Receiver controlled on/off switch for higher voltages
View Single Post
Old 01-09-2018 | 06:33 AM
  #6  
billdelong
Tech Champion
iTrader: (33)
 
Joined: Mar 2011
Posts: 6,410
From: Austin,TX
Default
Originally Posted by Jim85IROC
Was it even necessary to use the channel mixing on the controller for the brake lights? You could have used the y-splitter for the brake lights just like you did for the forward lights as long as you reversed the polarity of the LED.
Pretty easy for a brushed motor, but not sure how the wiring would work for a brushless setup, will you show a diagram for that please?
billdelong is offline  
Reply