Originally Posted by
30Tooth
Now that you mention ic TC yes, their suspension is similar to that one I shared and has less roll than normal electric TC. The main points are the upper arm angle and upper arm length compared to the lower arms. If that generates more grip depends on many tire parameters like sensitivity to load, construction and chemical composition.
yeah for sure, I’ve done some testing myself but in gt 1/8, I basically tried convencional stand up shocks and then I DIY some extensión like those found on 1/8 IC Lola and I found that the car improve in many area it would carry much more speed through through the corners , chassis roll decrease quite a bit, it was less likely to lose the rear end mid corner, better steering and it was overall better, now I’m looking to get into 1/10 EC but I find the suspension to be quite Rollie and not nimble enough, could you further eloborate in the suspension ideas ? That i could potentially use? Right know I’m wanting to do something very similar to a 1/10 IC suspension geometry