Originally posted by pk
Hi dino.tw!!!
I just got and installed my STS28 yesterday.
I just have two concerns....
1. When I was configuring the radio, There are times when the carb gets stuck when im attempting to go WOT. What i usually do is 'double clutch' the throttle, which seems to 'unstuck' whatever is blocking the slide.
2. On the CG image of the shaft starter, i noticed that the hole for the rotostart is at the side. Will this fit the savage? I mean, the savage's rotostart hole is on the upper left corner. I hope you could accomodate us Savage owners 
Right now im pumping some iron and strengthening my pullstart arm as im about to break in the beast! haha!
I'm back! Sorry it's very busy lately.
1) If you feel the slide valve is not so smooth,most of the cases are stuck by the idle screw. The edge of the valve's groove may not smooth enough. Please take off the idle screw and check the valve's groove or the idle screw. I will ask our factory to check it again.
2)I will get the sample next week. And I will report to you how its going.
Thanks,
Dino