R/C Tech Forums - View Single Post - RCHourglass DIY Lap Timing (AKA Cano revised)
Thread: RCHourglass DIY Lap Timing (AKA Cano revised)
View Single Post
Old 12-30-2017 | 06:59 AM
  #20  
mv4wd
Tech Regular
 
Joined: Mar 2015
Posts: 358
Default
Originally Posted by mroc
It is possible to use the low dotage or not
The standard PIC (no LF) has a min power voltage of 2.5 volt from specs, so it should work. Only output will be lower and/or distorted given the lower voltage swing and drive capability at lower Vdd voltages.
If you skip the voltage regulator it should work
mv4wd is offline  
Reply