Hey guys, first post here on rctech. Names Matt, been in and out of the hobby for over a decade, finally slowly getting back into it now and picked back up on a project I started a few years back.

Long story short, I got a miss matched bag of parts that was enough to build a Losi 1/24 micro sct, came with a no name brushless system and a cheap micro 3 wire servo.

Fast forward 2 years and with my new 3d printer started designing a rwd touring car chassis and stretching it to ~1/18th scale.

I'm on the road right now. But the I will get some pictures up of what I've got so far later on in the evening. But essentially here's what I've got done to it..

Lengthened and widened chassis
Rwd only
Brushless with custom motor mount
Upper chassis brace and esc and receiver holder
Custom bellcrank steering system
Custom rims
Custom road rage tires
Custom body (wip)

So yea, been quite a fun and headache endured build. Runs pretty good, need to tweak some stuff to tone down over steer in the turns.

Anyway, that's all for now!