R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 12-16-2017 | 01:42 AM
  #15113  
ozziii's Avatar
ozziii
Tech Master
 
Joined: Jul 2012
Posts: 1,425
From: Echuca, Victoria, Australia.
Default
Originally Posted by Palebushman
That Piston, liner and con-rod kit is one of the alternatives that I use on any of my GO based engines Paul. Your Godzilla and my MG66's have an extra transfer port under the inlet port and more refined fluting up to the ports. The timing, if you need a little more 'Snap', is done by adding special STEEL shims under the lip of the liner. They come in various thicknesses .01mm, .02mm and .03mm etc, but remember, you must remove the corresponding size button shim otherwise you will DECREASE compression. PM me if you need any further help or info on where to soure your GO Engines spares.

Thanks PaleBushman, just what I wanted to hear, will need to do something about it soon I think, probably after xmas some time.
As long as them parts would still make it go ok then that would be ok, although I might have to talk to you about some parts if you can get them.
Thanks.
ozziii is offline  
Reply