View Single Post
Old 12-09-2017, 06:40 AM
  #95  
MatsNorway
Tech Regular
 
Join Date: Jul 2009
Posts: 499
Default

That will not last long in an impact. Unless flexible on impact so the loads go into the rim. I guess a one or two piece steering hub could do it.

It is ok to chase ideas but a simple one while you tinker is ok too. Standing up is not a big handicap if done right. You do not get the screws on the top etc.

If the ideal wheel angles is purely down to the length of the links you can run shorter arms on the wheelhub and put the link on the inside of the wheel like a regular car.

As for rubbing the wheel you make it bent so it goes around the wheel rim when turned inn. Can the link go as far in as shown on the outside?
MatsNorway is offline  
Reply With Quote