Originally Posted by
cmbscx10
The overall problem with measurements of the motors is that they never include what the sensor wire takes up. Figure 3mm for that.
I run the XR8+ and the G2 4274. I chose this combo specifically due to where the sensor wire comes out being on top of the can vs in the center. It gave me a little wiggle room and I have a C hair left for a little Chassis flex.
I doubt you will be able to run a Truggy motor at 77mm plus the sensor wire but could be totally wrong.
If geared correctly, running a low kV and not running heavy MT tires a buggy motor would be just fine IMO.
Agree. I ran the XR8 Plus with the Tekin 2000 truggy motor in my ET48.3. It’ll fit with the sensor, but there’s virtually no room for chassis flex and I destroyed 2 sensor wires quickly before I gave up and switched to the XR8 SCT Plus for its smaller footprint. It runs my truggy perfectly on 4S and I used the same ESC in my MT410 with a Hobbystar 74mm 2000kv motor. Only problem with the SCT - can’t run 6S.