Originally Posted by
Krio
What happens when you do a bench test with the electronics on and go full left or right on the servo? Does it twist the gearbox and servo mount enough to make contact?
no twist on the gearboxes, I set my EPA's a tad lower than where full lock is for that.
Good to know though it wasn't just me seeing that lol.
I do have some other washers to use so will see how it goes just using the risers and then the stockers. Only thing that sucks is it grooved pretty hard on the other shaft so may have to look into buying another one. Heck, maybe an excuse to get some aftermarket wunder shaft
