R/C Tech Forums - View Single Post - Tekin Pro4 screw sizes??
Thread: Tekin Pro4 screw sizes??
View Single Post
Old 11-21-2017 | 07:46 PM
  #3  
iluvmud's Avatar
iluvmud
Tech Master
iTrader: (89)
 
Joined: Apr 2006
Posts: 1,628
Default
Originally Posted by Andy Koback
If you're talking about the sensor end cap, (short ones) the stock motor ones are 2.5mm X 8mm. Don't know if the Pro 4 motor would be the same or not. Hopefully someone else can chime in on this.
That might be it... I measured length (in inches) and it seems to be the right fit.... unless someone can actually confirm for a pro4

Thanks Andy for checking.... wish I had a regular Tekin motor to compare it to.
iluvmud is offline  
Reply