Hello,
I bought an Iwata Eclipse HP-BCS and an Olympo TC-80 automatic compressor (0 to 40 psi).
I am new so I wanted to clear some doubts.
Is it normal for the compressor to drop from 35 psi, to 20psi when I am using the airbrush? In fact, it doesn't matter what pressure do I start with, it will always drop to 20psi when I use it.
I can not get the airbrush to draw a thin line. I mean, it is not even close. From what I have seen on the internet I should get a 0.2cm line for example, and the smaller I can paint is a line of 0.7cm which is a lot!
Thanks! Hope somebody clears my mind!