Originally posted by TeamPRP
I'm considering making Roll center plates for the Mission that would allow an easier way to change roll center. The only mod you would need to make is cutting off a little bit of the top of the servo saver pipe, like 1 - 2mm.
is this something you guys would like?
Would you prefer them in Carbon Fiber plate, fiberglass or plastic?
Is there a need to change roll center in the rear? We could make both front and rear. We can also do them in different thicknesses to adjust roll center from say 2mm and 3mm, less, more?
Would anyone be intersted in this? Let me know what you think. Feel free to email at, [email protected]
Thanks much,
Ben, Team PRP
I have run my car the way your saying earlier this year. Its ok, but I think I like it better with the Fireblade blocks. Been running it this way for 3 or 4 months now. I hardly now bend front lower hinge pins. Also this way you don't raise the steering bellcranks and change the steering geometry. Don't get me wrong, it works either way.
