Originally Posted by
greener74
What is your method for putting the center diff back in? I had troubles this weekend and took about a half an hour trying to come up with an easy method. What I ended up doing was taking the top front screws out of the motor mount, and the bottom two screws out of the plastic rear diff mount. Then you can pull the top plate with the rear mount still attached. That gave me more room to get the bones back in.
Remove top four screws to remove diff. When putting back in insert front drive shaft in the cup first, then angle the diff upward and the rear shaft angled up also. line up the slot with the drive pin and push down and it will slip in nicely. It takes a few times to get it but once you get it down its as easy as Xray and AE.