Originally Posted by
chad508
Quick question on tie rod angle. I always try to have my tie rods flat but I have always noticed on the crc it’s not easy to do. I try to shim the outside up as much on the knuckle. But even then it’s not flat. I found the small sanwa with small kimbrough saver to be the closest but I prefer to run the Xray saver as I feel it’s a better saver. Is this something most don’t worry about and should I just get it as close as I can and move on. Any help would be great.
If you use the middle holes on the xray saver, and space up the ball studs on the spindle, just to the point where the ball cup is almost touching the inner wheel, itll be as near flat as possible. I'll snap a pic later and attach it on here.