R/C Tech Forums - View Single Post - Serpent Project 4-X
View Single Post
Old 08-31-2017, 07:49 PM
  #362  
WagwanBumba
Tech Fanatic
iTrader: (1)
 
Join Date: Jul 2014
Location: Hong Kong
Posts: 887
Trader Rating: 1 (100%+)
Default

Originally Posted by dan_vector View Post
In my testing outdoors the car is loose at the rear because it is rolling too much to the extent it's rolling off the rear tyre. It needs to be much stiffer in roll. Hence the blank pistons and 2-3k oil in the roll dampers. I'm up to using blues and grey springs in the roll dampers and the car is much better. I don't have the loose rear-end anymore in high speed corners. It just seems the harder I go the better the car gets. Bear in mind I'm running all the latest parts. I'm actually 1mm less shims under the rear upper arm mounts too. The car is getting better every run.
Roll centres were definitely too low stock. I've gone up to med-high roll centre on rear and 2mm shims all around. When running stock, the amount of wear on the carbon were a dead give away the rear was washing out hence loose rear on-power.

I just need to try these new parts once I've finished experimenting with the XQ1
WagwanBumba is offline