Originally Posted by Typpo

Thank you for posting the helpful pictures and description.

How well do the Durango driveshafts fit into the Schumacher diff outputs? Is there greater play between these driveshafts and the diff outputs? they fit perfectly

Do you know the diameter of the cross pin at the diff output (e.g. is it 2.5mm like the Schumacher driveshaft or is it thinner (e.g. 2.0mm)?
don't know the diameter
Also, what is the diameter of the ball end of the driveshaft that the cross pin fits through? Is it closer to 6mm or 7mm?never measured the ball

Beyond driveshafts, did you need to modify the front and rear arms (e.g. increase hinge pin opening and remove material from the arms to fit)?didn't have to remove any material from the front arms..just added three plastic washers on each side..the rears i had to grind material away...schumacher's pins are larger...need to get a drill bit 3.26 is the actual diameter