Originally Posted by
EbbTide
To fit those electronics, you just need to be smart about wire management. Not gonna lie though, it'll be a tight squeeze. You may only have 10mm of space between the ESC and motor.
And I'd start at 15 for the pinion and see how you like the power and see if motor/ESC temps are happy.
Ya I've had an et48 with a mm2 and a eb48 with an older hwxerun which were both tight squeezes so I am familiar with how to run the wires in the tekno chasis but I just wanted to make sure they did in deed fit and if I would have to modify anything
I am having a very hard time deciding which electronics to get. Either strip out my eb48.3 rx8/1900kv combo or go with another tekin setup, hw or castle. Im a very indecisive person lol.
I am also having a hard time with the servo. I have a savox 2274 which is good specs for buggies and truggies (367/.08). Will that be plenty of torque for this truck or should I be looking for over 400oz? I have found some around 450oz but they are around .12-.15 speeds. Not sure if that is too slow. Or if I wouldn't even tell the difference between .13 and .08