R/C Tech Forums - View Single Post - Tamiya mini cooper
Thread: Tamiya mini cooper
View Single Post
Old 07-13-2017 | 06:34 PM
  #29420  
monkeyracing's Avatar
monkeyracing
R/C Tech Elite Member
iTrader: (10)
 
Joined: Mar 2008
Posts: 6,305
From: Calgary, AB
Default
Originally Posted by TheOtherBill
Hey guys I am building a MO-5 V2 and installed a Tamiya Ball Diff. Set#54194. Tried to install the front axels (kit dog bones) and they are too short, I am thinking I need the Univ. Shaft kit # 53597? It has been quite some time since I built a Mini and seems like I have forgotten a lot about them. Will the MO-3 Univ. Shaft kit # 53597 work with the Ball diff. set # 54194 in my MO-5 V2? Thanks for any info.
Yes.

As for the stock dogbones, did you try putting on o-ring in the outdrive cups on the diff? I had a problem once when using the TA03 diff (even with universals) where the dogbone ends would fall out.
monkeyracing is offline  
Reply