Originally Posted by
Qrio
After tightening the plastic collar TKR5353, my clutch bell has an end play of at least 3mm. I'm new to nitro & Tekno but I understand the end play should only be about 0.5mm.
Did I install the plastic collar correctly?
Before collar:
After collar:
Yes. you can add a shim to the collar and see if that takes some of the play out. I had a similar issue and I put a shim from motor to collett, 2 shims from nut to rear bearing and 1 shim on the plastic end piece. On my other motor i put 2 shims between collet and motor, 2 shims between nut and back of bearing and 1 shim on the end.