Originally Posted by
Teufel Racing
Just got mine in today and had zero issues,
Even did a software upgrade to 258 from 255
Not sure what the issue is for ya,
I do know when the app is opened, but not connected to the ESC the app does show the default app settings, but once the Hotwire reads the ESC, all my settings came up on both my phone and iPad
My Hotwire app for the iOS will not read the current esc settings. If I turn the power switch off on my RX4, and turn it back on, I have to go through the whole re-binding process with the Bluetooth. Then I'm back to square one.
I did figure out the fan slider switch on the app. When it's connected via Bluetooth, if I tap default on the left menu, it will turn my fan to "on". But if I turn the power switch off on the RX4, physically disconnect the Hotwire from the esc, or unplug my lipo, I have to go through the Bluetooth re-binding process and all of the settings on the app show default settings. I made sure to tap "apply" after I made adjustments and tapped "drive" to disconnect the Hotwire. It's all good until I disconnect power from the Hotwire.
I beginning to think that I got a faulty Hotwire.