R/C Tech Forums - View Single Post - Radio Benchmark program and results.
Thread: Radio Benchmark program and results.
View Single Post
Old 06-30-2017 | 07:32 AM
  #6  
condac
Tech Apprentice
 
Joined: Jul 2014
Posts: 86
From: Sweden
Default
Originally Posted by billdelong
I've had pretty good success measuring latency with the PPM monitor built into this gadget:
SkyRC 6 in 1 Program Box

Simply hook up the output from either Ch1 or Ch2 from Rx into the Program Box and switch to PPM mode and it will read out the frame rate in Hz, then I use this conversion tool here to get the frame rate in ms:
https://www.unitjuggler.com/convert-...-to-ms(p).html
Is this how your frame rate values in the comparision table you have is created? In that case I'm realy confused because you have stated a lower(better) framerate on the Radiolink than the GT3B when the hz is higher in the GT3B when I tested. Also the radios that have around 1ms frame latency must have very high hz.
condac is offline  
Reply