Hey guys, hoping someone can help me out a bit. I just received 2 reventon pro's and installed them. I calibrated them both and they were working fine. I then wanted to program them both for blinky mode so I updated the firmware on one of my programmers via the usb cable. The first esc set up went fine and is operating with no issues, the 2nd however is not working at all now. When i connect the program card alone with a lipo OR using the usb and no lipo it wont go into any sort of programming options AND now it wont even turn on as it did in the car connected normally. The light comes on but no throttle response. When i connect it to the usb/card it says "connecting pc". I then load up the SP software and it just continually prompts me "connect esc". I can tell it notices the esc is there because it only prompts me when i plug the esc in.
Any ideas?
Thanks